Yield Lab

Abstract: All the materials were measured and weighed. It was found in the experiment that the yield of copper hydroxide in 40%.

Introduction: The copper (II) sulphate is then placed in 100 mL of distilled water. Then 20 mL of CuSO4 is measured and placed 100 mL of distilled water. This can later be weighed to determine the mol of CuSO4 and the mol/L concentration. Then this was used to find out how many mL of 0.5 NaOH solution is needed to react completely with all the copper (II) sulphate in solution. Then titrate ј of the estimated amount number of mL of NaOH needed to react with the sulphate solution. Then add 5 mL at a time NaOH until Cu(OH)2 precipitate does not form. Record the correct number off mL which forms to NaOH solution. Fold the filter paper and stick inside the funnel, and pour the solution of copper (II) hydroxide through the filter. The purpose of this experiment is to determine the yield of copper (II) sulphate reaction.

Reagent preparation:

0.5 mol/L = mol/0.1L

0.5 (0.1L)=mol

mol = 0.05

0.05 x 40 (molar mass)= 2

There are 2 grams of solid sodium hydroxide.

Method:

Weigh 100 mL beaker

Transfer anhydrous copper (II) sulphate to that beaker

Heat beaker at level 6 for 3 minutes, stirring occasionally

Removing beaker from balance and weigh after cooling for 3 minutes

Turn off heater (or leave for next group)

Measure 100 mL of distilled water into a graduated cylinder and place in 100 mL beaker with the copper (II) sulphate

Heat and mix until solid material is all gone

Let cool for 5 minutes

Measure 20 mL of CuSO4 into 200 mL beaker, and add 100 mL of water

Calculated mol of CuSO in solution and the mol/L concentration

Predict how many mL of 0.5 NaOH solution is needed to react completely with all the copper(II) sulphate in solution

Place 200 mL beaker under the titrating burnette

Record the number of mL in the burnette

Titrate quickly ј of the estimated number of mL of NaOH needed to react completely with the sulphate in the solution

Carefully 5 mL at a time, add NaOH until Cu(OH) precipitate does not form anymore

Record the final number of mL in the burnette

Weigh a piece of filter paper

Fold the paper and place in funnel. Place one of the discard solution beakers under the funnel

Mix and pour (slowly) the solution of copper (II) hydroxide slurry through the filter

When finished collecting the precipitate, use a paper towel to place it on the drying tray, and identify it with your name with tape.

Clean your beakers. Pour your NaOH into a collection flask.

Results:

The results for the yield lab is:

7 (actual mass)

12 (estimated mass)

=0.5833333 x 100

=58.3 %

As illustrated on this paper it shows that the percentage we got on this lab is 58.3%. We got this by dividing the actual mass, and our estimated mass.

Calculations:

1. Weight of copper (II) sulphate: 2.13 grams

51.90 (beaker + copper (II) sulphate)

- 49.77 (beaker)

2.13 (copper (II) sulphate)

2. Weight of anhydrous sulphate: 2.39 grams

63.11 (beaker + anhydrous sulphate)

- 60.72 (beaker)

2.39 (anhydrous sulphate)

3. Moles