Nortel Meridian

INPUT/OUTPUT CRASH COURSE

Meridian crash course

faq798-5880

Posted: 20 May 05 (Edited 3 Jun 05)

Programming Meridian SL1 PBX

This is a short introduction into programming a Meridian PBX. The Meridian PBX's software divides information into LOADS. Each Load has a specific function for example. LD 20 is where you can print information about phones. The loads range from LD 01 - LD 143

How to HyperTerminal in to the PBX and VOICEMAIL Systems.

1. Launch HyperTerminal

2. Set phone number to your modem dialin number

3. Set terminal emulation to VT102 X Modem

4. Dial… it should end up at a blank HyperTerminal window

5. Type the password to access the PBX modem. This will not show up on the screen when you type it. The screen should now display “Ok, You are now transparent to port 1”.

6. Type “logi” to login, then the password.

7. You should now have a > command prompt.

To go from PBX commands to VOICEMAIL