Current and Resistance of a Wire and the Affects When the Length Changes

Current and Resistance Physics Investigation

Aim:

Investigate how the length of a wire affects the current and resistance of a wire.

Prediction and Hypothesis:

I think as you increase the length of the Constatan wire, you also increase the amount of resistance. The current is the flow of electrons; the current is dependent on the amount of voltage, which is applied. Voltage is the push given to the current. The current has to go through a circuit, which contains resistance so if you increase that push you also increase the flow of the current. All materials have a slight resistance to electricity factors affecting the resistance are: Length, Voltage & Temperature and Surface Area

Length

The diagram shows the happenings of a wire

the blue dots represent some of the negative

electrons which leads to a lower voltage output,

when the length is increased.

Voltage & Temperature

Temperature has an affect on the experiment as the voltage has control over the temperature. The more the temperature increases the more the particles vibrate leading to a reduction in output voltage although not by a huge amount this does have an affect.

Density

Density has a large affect on the amount of resistance. The resistance depends upon the amount of denseness e.g. a large surface area has less resistance because a small area has tightly packed atoms which in turn rebound many of these electrons.

Apparatus:

· Power Pack

· Constatan wire

· Leads

· Voltmeter

· Ammeter

Method:

1. Arrange apparatus as shown in the Diagram:

2. Cut wires to the following lengths:

· 30cm

· 60cm

· 90cm

· 120cm

· 150cm

3. Attach the wire to the crocodile-clip leads and set voltage to 5 volts or 1.5 Volts

4. Take the reading from the ammeter and record in results table.

5. Repeat 4 times for each length of wire and find the average.

6. Then work out the resistance using the formula VчI=R

(Voltage ч Current = Resistance)

Preliminary Experiment

We carried out a preliminary experiment to see the other factors that could affect the experiment and also to see if we could improve any of the steps in the method. This showed that the wire was very weak if given more than 5 volts because the wire lets electricity flow faster and faster which then leads to the heat eventually breaking the wire. I found that if I decreased the voltage to a reading of 1.5 volts the wire stayed in tact enough to give a good reading and thereby giving better overall results.

Voltage used 5 Volts

Length

Current (1)

Current (2)

Current (3)

Current (4)

Average

Resistance

30cm

4.4

4.6

4.6

4.7

4.5

1.1

60cm

2.3

2.4

2.2